If you don’t have EAGLE, download the files in PDF format here.Įtch the PCB using the layout provided(If you don’t know how to etch a PCB, see this tutorial). The EAGLE schematic and board files can be downloaded here. I also wanted the debugger to act as a programmer for non-JTAG capable devices, so I had to create everything from scratch on EAGLE and make a board layout. If the converter is TTL compatible, which it will be in most cases, you won’t need the level shifter IC (MAX232). Since I don’t own an ancient PC, I was forced to use a USB to serial converter. The only drawback of this debugger is that it supports only a limited number of microcontrollers but hey its open source and dirt cheap to build, so what did you expect?ĪTmega16(L), ATmega162(L), ATmega169(L or V), ATmega32(L), ATmega323(L), ATmega64(L), ATmega128(L). The AVR JTAGICE(not mkII) however, has been made open source by Atmel and therefore anyone can build it. The problem is they cost hundreds of dollars and are hard to get in India. AVR has many debuggers like the AVR Dragon, AVR One, AVR JTAGICE mkII etc. Since I almost entirely use AVR, I’ll be showing you how to build an AVR debugger. A debugger will help you immensely when you’re in the prototyping phase of any project. Tired of putting LEDs every time you want to check some value in the microcontroller? Well, its time to build yourself a debugger.Ī debugger is a device which helps you run through your code in the microcontroller step by step and also gives you the ability to read or write the registers directly using the PC which means you can check the value of any register or any variable at any time without the need for any external components like LEDs or seven segment displays.

Avr jtagice mkii